Votre recherche

Abstract. Ice pellets can form when supercooled raindrops collide with small ice particles that can be generated through secondary ice production processes. The use of atmospheric models that neglect these collisions can lead to an overestimation of freezing rain. The objective of this study is therefore to understand the impacts of collisional freezing and secondary ice production on simulations of ice pellets and freezing rain. We studied the properties of precipitation simulated with the microphysical scheme Predicted Particle Properties (P3) for two distinct secondary ice production processes. Possible improvements to the representation of ice pellets and ice crystals in P3 were analyzed by simulating an ice pellet storm that occurred over eastern Canada in January 2020. Those simulations showed that adding secondary ice production processes increased the accumulation of ice pellets but led to unrealistic size distributions of precipitation particles. Realistic size distributions of ice pellets were obtained by modifying the collection of rain by small ice particles and the merging criteria of ice categories in P3.

Reliable precipitation forcing is essential for calculating the water balance, seasonal snowpack, glacier mass balance, streamflow, and other hydrological variables. However, satellite precipitation is often the only forcing available to run hydrological models in data-scarce regions, compromising hydrological calculations when unreliable. The IMERG product estimates precipitation quasi-globally from a combination of passive microwave and infrared satellites, which are intercalibrated based on GPM’s DPR and GMI instruments. Current GPM-DPR radar algorithms have satisfactorily estimated rainfall, but a limited consideration of PSD, attenuation correction, and ground clutter have degraded snowfall estimation, especially in mountain regions. This study aims to improve satellite radar snowfall estimates for this situation. Nearly two years (between 2019 and 2022) of aloft precipitation concentration, surface hydrometeor size, number and fall velocity, and surface precipitation rate from a high elevation site in the Canadian Rockies and collocated GPM-DPR reflectivities were used to develop a new snowfall estimation algorithm. Snowfall estimates using the new algorithm and measured GPM-DPR reflectivities were compared to other GPM-DPR-based products, including CORRA, which is employed to intercalibrate IMERG. Snowfall rates estimated with measured Ka reflectivities, and from CORRA were compared to MRR-2 observations, and had correlation, bias, and RMSE of 0.58 and 0.07, 0.43 and -0.38 mm h-1, and 0.83 and 0.85 mm h-1, respectively. Predictions using measured Ka reflectivity suggest that enhanced satellite radar snowfall estimates can be achieved using a simple measured reflectivity algorithm. These improved snowfall estimates can be adopted to intercalibrate IMERG in cold mountain regions, thereby improving regional precipitation estimates.

Abstract This study aims to characterize the shapes and fall speeds of ice pellets formed in various atmospheric conditions and to investigate the possibility to use a laser-optical disdrometer to distinguish between ice pellets and other types of precipitation. To do so, four ice pellet events were documented using manual observations, macrophotography, and laser-optical disdrometer data. First, various ice pellet fall speeds and shapes, including spherical, bulged, fractured, and irregular particles, were associated with distinct atmospheric conditions. A higher fraction of bulged and fractured ice pellets was observed when solid precipitation was completely melted aloft while more irregular particles were observed during partial melting. These characteristics affected the diameter–fall speed relations measured. Second, the measurements of particles’ fall speed and diameter show that ice pellets could be differentiated from rain or freezing rain. Ice pellets larger than 1.5 mm tend to fall > 0.5 m s −1 slower than raindrops of the same size. In addition, the fall speed of a small fraction of ice pellets was < 2 m s −1 regardless of their size, as compared with a fall speed > 3 m s −1 for ice pellets with diameter > 1.5 mm. Video analysis suggests that these slower particles could be ice pellets passing through the laser-optical disdrometer after colliding with the head of the instrument. Overall, these findings contribute to a better understanding of the microphysics of ice pellets and their measurement using a laser-optical disdrometer. Significance Statement Ice pellets are challenging to forecast and to detect automatically. In this study, we documented the fall speed and physical characteristics of ice pellets during various atmospheric conditions using a combination of a laser-optical disdrometer, manual observations, and macrophotography images. Relationships were found between the shape and fall speed of ice pellets. These findings could be used to refine the parameterization of ice pellets in atmospheric models and, consequently, improve the forecast of impactful winter precipitation types such as freezing rain. Furthermore, they will also help to physically interpret laser-optical disdrometer data during ice pellets and freezing rain.

Abstract The Canadian Precipitation Analysis System (CaPA) is an operational system that uses a combination of weather gauge and ground-based radar measurements together with short-term forecasts from a numerical weather model to provide near-real-time estimates of 6- and 24-h precipitation amounts. During the winter season, many gauge measurements are rejected by the CaPA quality control process because of the wind-induced undercatch for solid precipitation. The goal of this study is to improve the precipitation estimates over central Canada during the winter seasons from 2019 to 2022. Two approaches were tested. First, the quality control procedure in CaPA has been relaxed to increase the number of surface observations assimilated. Second, the automatic solid precipitation measurements were adjusted using a universal transfer function to compensate for the undercatch problem. Although increasing the wind speed threshold resulted in lower amounts and worse biases in frequency, the overall precipitation estimates are improved as the equitable threat score is improved because of a substantial decrease in the false alarm ratio, which compensates the degradation of the probability of detection. The increase of solid precipitation amounts using a transfer function improves the biases in both frequency and amounts and the probability of detection for all precipitation thresholds. However, the false alarm ratio deteriorates for large thresholds. The statistics vary from year to year, but an overall improvement is demonstrated by increasing the number of stations and adjusting the solid precipitation amounts for wind speed undercatch.

Abstract. This study presents a probabilistic model that partitions the precipitation phase based on hourly measurements from a network of radar-based disdrometers in eastern Canada. The network consists of 27 meteorological stations located in a boreal climate for the years 2020–2023. Precipitation phase observations showed a 2-m air temperature interval between 0–4 °C where probabilities of occurrence of solid, liquid, or mixed precipitation significantly overlapped. Single-phase precipitation was also found to occur more frequently than mixed-phase precipitation. Probabilistic phase-guided partitioning (PGP) models of increasing complexity using random forest algorithms were developed. The PGP models classified the precipitation phase and partitioned the precipitation accordingly into solid and liquid amounts. PGP_basic is based on 2-m air temperature and site elevation, while PGP_hydromet integrates relative humidity. PGP_full includes all the above data plus atmospheric reanalysis data. The PGP models were compared to benchmark precipitation phase partitioning methods. These included a single temperature threshold model set at 1.5 °C, a linear transition model with dual temperature thresholds of –0.38 and 5 °C, and a psychrometric balance model. Among the benchmark models, the single temperature threshold had the best classification performance (F1 score of 0.74) due to a low count of mixed-phase events. The other benchmark models tended to over-predict mixed-phase precipitation in order to decrease partitioning error. All PGP models showed significant phase classification improvement by reproducing the observed overlapping precipitation phases based on 2-m air temperature. PGP_hydromet and PGP_full displayed the best classification performance (F1 score of 0.84). In terms of partitioning error, PGP_full had the lowest RMSE (0.27 mm) and the least variability in performance. The RMSE of the single temperature threshold model was the highest (0.40 mm) and showed the greatest performance variability. An input variable importance analysis revealed that the additional data used in the more complex PGP models mainly improved mixed-phase precipitation prediction. The improvement of mixed-phase prediction remains a challenge. Relative humidity was deemed the least important input variable used, due to consistent near water vapor saturation conditions. Additionally, the reanalysis atmospheric data proved to be an important factor to increase the robustness of the partitioning process. This study establishes a basis for integrating automated phase observations into a hydrometeorological observation network and developing probabilistic precipitation phase models.

Abstract The Canadian Precipitation Analysis (CaPA) system provides near-real-time precipitation analyses over Canada by combining observations with short-term numerical weather prediction forecasts. CaPA’s snowfall estimates suffer from the lack of accurate solid precipitation measurements to correct the first-guess estimate. Weather radars have the potential to add precipitation measurements to CaPA in all seasons but are not assimilated in winter due to radar snowfall estimate imprecision and lack of precipitation gauges for calibration. The main objective of this study is to assess the impact of assimilating Canadian dual-polarized radar-based snowfall data in CaPA to improve precipitation estimates. Two sets of experiments were conducted to evaluate the impact of including radar snowfall retrievals, one set using the high-resolution CaPA (HRDPA) with the currently operational quality control configuration and another increasing the number of assimilated surface observations by relaxing quality control. Experiments spanned two winter seasons (2021 and 2022) in central Canada, covering part of the entire CaPA domain. The results showed that the assimilation of radar-based snowfall data improved CaPA’s precipitation estimates 81.75% of the time for 0.5-mm precipitation thresholds. An increase in the probability of detection together with a decrease in the false alarm ratio suggested an improvement of the precipitation spatial distribution and estimation accuracy. Additionally, the results showed improvements for both precipitation mass and frequency biases for low precipitation amounts. For larger thresholds, the frequency bias was degraded. The results also indicated that the assimilation of dual-polarization radar data is beneficial for the two CaPA configurations tested in this study.

Several configurations of the Canadian Precipitation Analysis system (CaPA) currently produce precipitation analyses at Environment and Climate Change Canada (ECCC). To improve CaPA’s performance during the winter season, the impact of assimilating the IMERG V06 product (IMERG: Integrated Multi-satellitE Retrievals for GPM—Global Precipitation Measurement mission) into CaPA is examined in this study. Tests are conducted with CaPA’s 10 km deterministic version, evaluated over Canada and the northern part of the United States (USA). Maps from a case study show that IMERG plays a contradictory role in the production of CaPA’s precipitation analyses for a synoptic-scale winter storm over North America’s eastern coast. While its contribution appears to be physically correct over southern portions of the meteorological system, and early in its intensification phase, IMERG displays unrealistic spatial structures over land later in the system’s life cycle when it is located over northern (colder) areas. Objective evaluation of CaPA’s analyses when IMERG is assimilated without any restrictions shows an overall decrease in precipitation, which has a mixed effect (positive and negative) on the bias indicators. But IMERG’s influence on the Equitable Threat Score (ETS), a measure of CaPA’s analyses accuracy, is clearly negative. Using IMERG’s quality index (QI) to filter out areas where it is less accurate improves CaPA’s objective evaluation, leading to better ETS versus the control experiment in which no IMERG data are assimilated. Several diagnostics provide insight into the nature of IMERG’s contribution to CaPA. For the most successful configuration, with a QI threshold of 0.3, IMERG’s impact is mostly found in the warmer parts of the domain, i.e., in northern US states and in British Columbia. Spatial means of the temporal sums of absolute differences between CaPA’s analyses with and without IMERG indicate that this product also contributes meaningfully over land areas covered by snow, and areas where air temperature is below −2 °C (where precipitation is assumed to be in solid phase).